Previous kms and PTO blower time regulated engine oil and filter changes at approximately 1 month per unit. Since the installation of the Kleenoil auxiliary oil system, the oil and filter changes have been extended up to 4 months. All units are subject to oil sampling and analysis reports at 15,000 km intervals. The usual oil analysis report returned reads "Data indicates no abnormal findings; re sampl...
| Kleenoil Onboard Oil Recycling Systems |
|
|
|
|
The Kleenoil Onboard Oil Recycling System is a bypass oil filtration system that passes only a small portion of the total oil flow through a very dense filter cartridge at about 2 to 3 quarts per minute. At this speed, it is possible to remove particles down to 1 micron (3 absolute) and remove 99.95% of all water, greatly decreasing engine wear and prolonging oil life. Kleenoil can eliminate water and particle contamination, extend oil life up to 5 times and hydraulic oil up to 10 times, reduce engine wear and component wear, dramatically reduce downtime, remove particles down to 1 micron (3 absolute), and is applicable to engines as well as hydraulic systems.
The Kleenoil USA filtration unit is made of cast aluminum with a galvanized steel mounting bracket. There are five basic sizes, which are installed according to the applications table below. It is connected to the engine lubricating oil circulating system in a bypass loop using high pressure braided hose and fittings to SAE standards.
|